#Logitech quickcam pro 9000 webcam drivers#
0, that is the latest drivers from the latest QuickCam 11.8 software - so, essentialy, the correct drivers are reported as not installed (in the General tab) and installed (in the Driver tab) at the same time! Very strange.Īll on a fresh and fully patched Windows XP Professional SP3 Italian install, with still very few other programs added (so there should be no conflicts).
I incorrectly said that in the Device Manager it says that no driver is loaded (in the first, General tabs of the webcam and microphone properties): well, in reality it says that no driver is installed, while in the Driver tabs it correctly says (in both cases) that the driver is Logitech from version.
#Logitech quickcam pro 9000 webcam mac os x#
The host system is Mac OS X Leopard 10.5.5 on a Mac mini with 4 GB RAM (512 MB dedicated to XP and 1 GB to Vista).Īn update. In Mac OS X, the webcam works in basic mode, through the built-in UVC (USB Video Class) driver: and even so, the image is very good. In Vista, as I said, everything works perfectly: but of course I'd prefer to use the webcam and its full-featured Windows-only Logitech software (in Unity mode) through XP, as it is less resource hungry than Vista (the webcam has some tough system requirements). I know there have been other similar reports regarding Logitech webcams, but a solution doesn't seem to have been found, yet.
So, essentially, the webcam doesn't work: is this a Fusion problem? or an XP problem? or both?
There is a problem with this webcam and VMware Fusion 2.0 with a Windows XP SP3 guest (while it works OK with a Windows Vista guest): following the QuickCam software installation instructions, when it is time to plug in the webcam (through USB 2.0) it is indeed detected by XP as a Logitech QuickCam Pro 9000, but then the new hardware icon remains in the tray without any further progress if one disconnects and then reconnects the webcam via the Fusion status bar, the installation completes (and thus it also detecs the built-in microphone), but after the installation the webcam doesn't work and isn't detected within the QuickCapture software in the Device Manager everything seems to be OK (both the camera and the microphone are present and working, and without any yellow problem badge), but it says that no driver is loaded (while the correct drivers are indeed installed) disconnecting and reconnecting apparently also works, with the usual sounds and no new hardware messages, as if everything were OK.
0 kommentar(er)
